Zenoah GZ3500T Manuel D'utilisation page 23

3. Make sure that the throttle trigger and throttle trigger
lockout move freely and that the return spring work
properly.
4. Start the chainsaw and apply full throttle.
5. Release the throttle trigger and make sure that the
saw chain stops and remains stationary. If the saw
chain rotates when the throttle trigger is in the idle
position, contact your servicing dealer.
To do a check of the chain catcher
1. Do a visible check and make sure that there is no
damage on the chain catcher.
2. Make sure that the chain catcher is firmly attached to
the body of the chainsaw.
To do a check of the vibration damping
system
1. Do a check of the vibration damping units to make
sure that there are no cracks or deformation.
2. Make sure that the vibration damping units are
securely attached to the engine unit and handle unit.
To do a check of the start/stop switch
1. Start the engine.
308 - 004 - 27.09.2017
2. Press the start/stop switch downwards to the STOP
position. Make sure that the engine stops when you
do this.
To do a check of the muffler
1. Make sure that the muffler is not damaged.
WARNING: Never use a product that
has a faulty muffler or a muffler that is in
poor condition.
2. Make sure that the muffler is securely attached to
the product.
3. Loosen the screws A and B.
A
B
23