Zenoah GZ4350 Manuel D'utilisation page 11

• Length (inches/cm)
• Number of teeth on bar tip sprocket (T).
• Chain pitch (inches). The spacing between the drive
links of the chain must match the spacing of the
teeth on the bar tip sprocket and drive sprocket.
D
• Number of drive links. The number of drive links is
determined by the length of the bar, the chain pitch
and the number of teeth on the bar tip sprocket.
• Bar groove width (inches/mm). The groove in the bar
must match the width of the chain drive links.
320 - 005 - 27.09.2017
L
D
PITCH =
2
• Chain oil hole and hole for chain tensioner. The bar
must be matched to the chain saw design.
Saw chain
• Chain pitch (inches)
D
• Drive link width (mm/inches)
• Number of drive links.
Cutting equipment designed to reduce kickback
The only way to avoid kickback is to make sure that the
kickback zone of the bar never touches anything. By
using cutting equipment with "built-in" kickback reduction
and keeping the chain sharp and wellmaintained you
can reduce the effects of kickback.
Guide bar
The smaller the tip radius the lower the chance of
kickback.
Saw chain
A chain is made up of a number of links, which are
available in standard and low-kickback versions.
D
PITCH =
2
11