General Safety Instructions - LEMAN SOR250 Manuel D'utilisation

rotating part of the power tool may result in personal injury.
e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power
tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from
moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
g) If devices are provided for the connection of dust extraction and collection facilities, ensure these are
connected and properly used. Use of these devices can reduce dust related hazards.
4. Power tool use and care
a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do
the job better and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source before making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained
users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any
other condition that may affect the power tool's operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely
to bind and are easier to control;
g) Use the power tool, accessories and tool bits etc., in accordance with these instructions, taking into
account the working conditions and the work to be performed. Use of the power tool for operations different
from intended could result in a hazardous situation.
5. Service
a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
b) If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.

1. General safety instructions

1. Keep hands out of path of saw blade. Avoid contact with any coasting blade. It can still cause severe
injury.
2. Check the saw blade carefully for cracks or deformation before operation. Replace damaged blade
immediately.
3. Replace the table insert when worn.
4. Use only saw blades specified by the manufacturer and which conform to EN847-1.
5. Do not use blades of High Speed Steel (HSS blades).
6. Wear eye protection.
7. Wear hearing protection to reduce the risk of hearing loss.
8. Wear gloves for handling saw blades (saw blades shall be carried in a holder wherever practicable) and
rough material.
9. Connect miter saws to a dust collecting device when sawing.
10. Select saw blades in relation to the material to be cut.
11. Do not use the saw to cut other material than wood or similar materials.
12. Always secure all moving portions before carrying the tool. When lifting or carrying the tool, do not use the
guard as a carrying handle.
13. Do not operate saw without guards in place. Check blade guard for proper closing before each use. Do
not operate saw if the blade guard does not move freely and close instantly. Never clamp or tie the blade guard
into the open position.
14. Keep the floor area free of loose material e.g. chips and cut-offs.
15. Use only saw blades that are marked with a maximum speed equal to or higher than the no load speed
marked on the tool.
16. Do not replace the laser with a different type. Ask an authorized service center for repairing.
SPECIAL REQUIREMENTS FOR MITRE SAW
GB
26