Canceling A Cycle; Changing A Cycle Or Setting - KitchenAid KUDS01DL Guide D'utilisation Et D'entretien

Use this cycle for china and
crystal. This cycle uses a
light wash and gentle dry.
During the heated dry, the
heating element cycles on
and off.
Soil Rinse Main Rinse
Level Wash
Sensed
120°F
Heavy
(49°C)
120°F
Light
(49°C)
Use this cycle for a quick wash
and light dry to clean up
cookware prior to entertaining.
The sensor adds water and
time to the cycle, if needed, for
maximum cleaning. This cycle
uses a shortened dry time.
Towel drying may be needed.
Water Rinse Main Rinse
Temp Wash
Sensed
Hot
Cold
Use this rinse cycle for
rinsing dishes, glasses, and
silverware that will not be
washed right away.
Soil Pre- Rinse Main
Level Wash Wash
Sensed
A small amount of water is run through the pump to remove
†
soil particles between the main wash and final rinse.
NOTES:
The sensor in your dishwasher monitors the soil level. Cycle
time and/or water usage can vary from the numbers above as
the sensor adjusts the cycle for the best wash performance.
In the Normal cycle, the dishwasher pauses while soaking.
Soaking helps loosen soils on dishes for brilliant results.
Use main
detergent
dispenser section.
Purge† Final Dry Time
Heated (min)
Rinse
79*
135°F
cycled
(57°C)
71*
135°F
cycled
(57°C)
Use main
detergent
dispenser
section.
Final Dry Time
Heated (min)
Rinse
44*
48*
Do not use
detergent with
this cycle.
Rinse Final Dry Time
Heated (min)
Rinse
10
Anytime during a cycle, press the Cancel pad.
Water
Usage
(gal/L)
The display shows
7.1-8.6/
27-33
5.9/
22.3
Your dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press the Cancel pad again to stop the drain
immediately. Remember to drain the dishwasher before starting a
Water
Usage
new cycle.
(gal/L)
To clear the indicators
5.2-6.5/
20-25 Press the Cancel pad before starting the dishwasher to clear all
options and cycles.
7.1-8.2/
27-31

Changing a Cycle or Setting

During the first minute of a cycle
1. Open the door.
2. Press a new cycle and/or options.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
4. Close the door. The dishwasher resumes the new cycle
and/or option after a 5-second pause.
Water
Usage After the first minute of a cycle
(gal/L)
1. Press the Cancel pad.
1.8/7
The display shows
Your dishwasher starts a 2-minute drain (if needed). Let
the dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
2. Open the door.
3. Select a new cycle and/or options.
4. Check the detergent dispensers. They must be filled properly
for the new cycle.
5. Close the door.
6. Press the Start pad.

Canceling a Cycle

15