Mounting The Deflector; Stihl Autocut - Stihl FSE 60 Mode D'emploi

Mounting the Deflector

2
1
Push the deflector (1) over the
N
clamp (2) as far as stop.
4
Fit the locknut (3) in the hex recess
N
on the deflector.
Make sure the holes line up.
N
Insert the M6x30 screw (4) and
N
tighten it down firmly.
FSE 60, FSE 71, FSE 81
Mounting the Cutting
Attachment
Placing Power Tool on the Ground
Switch off the power tool.
N
Lay your trimmer on its back with
N
the loop handle facing down and the
output shaft facing up.
3
Fitting Mowing Head without Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.

STIHL AutoCut 5-2

4
2
1
3
Fit the spring (1) in the mowing
N
head (2).
Wind the mowing line (3) on to the
N
spool (4).
Thread the nylon line through the
N
sleeves and fit the spool in the head.
The individual steps are described in the
instruction sheet supplied.
English
3
37