Hendi Arktic 271575 Mode D'emploi page 16

Descaling the machine
Minerals that are removed from water during the
freezing cycle will eventually form a hard scaly
deposit in the water system. Cleaning the system
regularly helps remove the mineral scale buildup.
How often you need to clean the system depends
upon how hard your water is. With hard water of 4
to 5 grains/liter, you may need to clean the system
as often as every 6 months.
1. Turn off the ice maker. Keep the ice maker con-
nect to the water supply and drainpipe. But shut
off the water faucet of main water supply.
2. Open the door and scoop out all of the ice cubes.
Either discard them or save them in an ice chest
or cooler.
3. Making the cleaning solution. Please mix the
Nu-Calgon Nickle Safe Ice Machine Cleaner with
water to make the cleaning solution.
WARNING: Wear rubber gloves and safety goggles
when handling Ice Machine Cleaner
Use a plastic or stainless container with more than
4 liters capacity, mix 300 ml Nu-Calgon Nickle
Safe Ice-machine Cleaner with 2.8 liters warm wa-
EN
ter about 50-60ºC, Then divide them for 2 shares
equally in 2 cups. It is better to keep the tempera-
ture of each cup of the cleaning solution.
4. Check to be sure that the water drain pipe of
the water tank has been installed properly in
the slot of the tank wall. Then Pour one cup of
Nickel-Safe Ice Maker Cleaning Solution into the
water tank. Wait about for 5 minutes.
16
5. Turn on the power to the ice maker, then press
" " button on control panel for more than 5 sec-
onds, to enter the self-Cleaning program. During
this process, the "Clean" light will always be on
during this period, and the digit window will indi-
cate the time left.
6. After self-cleaning program, pull out the drain
pipe of the water tank, drain the cleaning solu-
tion down to the lower ice storage bin. Shake the
unit slightly to drain out all of the cleaning solu-
tion completely. Then install back the drain pipe
to the slot of the water tank.
7. Repeat steps 4--6 to clean the ice making as-
sembly system again.
WARNING: The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based
cleaner products. Use rubber gloves to protect
hands. Carefully read the material safety instruc-
tions on the container of the ice machine cleaner.
8. Open the water faucet of the main water supply,
let the water flow in the unit. Again press the" "
button on control panel for more than 5 seconds,
to enter the self-Cleaning program. Through
this process, It will rinse the water dividing pipe,
evaporator, water pump, silicone pipe, and water
tank, etc..
9. After one self-cleaning program complete, then
pull out the drain pipe of the water tank, drain
the cleaning solution down to the lower ice stor-
age bin, also shake the unit slightly to drain out
all of the water completely. Then install back the
drain pipe to the water tank slot tightly.
10. Repeat the step 8-9 again 2 times.
11. Following the above program to clean the ice
storage bin.
12. Discard the first batch of ice cube.