Hendi Arktic 271575 Mode D'emploi page 10

Unpacking your ice maker
1. Remove the exterior and interior packaging.
Check if all the accessories, including instruc-
tion manual, ice scoop, white water inlet pipe, 4
ways to 2 ways water quick connector and the
water draining pipe, etc., are inside or not. If any
parts are missing, please contact our customer
service.
2. Keep the packaging if you intend to store your
appliance in the future.
3. Remove the tapes for fixing the door and inned
cabinet, ice scoop, etc.. Roughly clean the inner
cabinet & ice scoop with wet clothe.
Installation location requirement
a) Keep the proper room temperature and inlet wa-
ter temperature according to above specification
table. Otherwise it will affect the ice making per-
formance.
b) This unit should not be located near any heat
source.
EN
When installing the ice maker under a counter, fol-
low the recommended spacing dimensions shown
above. Place electrical and water supplies and
drain fixtures in the recommended locations as
shown.
Choose a well-ventilated area with temperatures
above 10˚C and below 32˚C. This unit MUST be
10
Installation clearance top view
(1:10) (mm)
200
Rear of appliance
200
Side of appliance
Front of appliance
200
4. Put the ice maker on a level & flat floor, without
direct sunlight and other sources of heat (i.e.:
stove, furnace, radiator). Maker sure that there
is at least 20cm gap between the air outlet and
the obstacles, and at least 5 cm between Left/
Right side and the wall.
5. Allow 4 hours for the refrigerant fluid to settle
before plugging the ice maker in if the unit may-
be fall upside down during shipping or transpor-
tation.
6. The appliance must be positioned so that the
plug is accessible.
WARNING: Only use drinking water to make ice.
c) The unit should be located on a firm & level foun-
dation at normal counter top height.
d) There must be at least 200mm clearance around
the appliance and 40mm clearance from the top
to keep good air ventilation.
e) Do not put anything on the top of the ice maker.
200
installed in an area protected from the elements,
such as wind, rain, water spray or drips.
The ice maker requires a continuous water supply
with pressure 1-8 Bar as required in above speci-
fication table. The temperature of the water feed-
ing into the ice maker should be between 5˚C and
25˚C for proper operation.
Side view (mm)