Hendi Arktic 271575 Mode D'emploi page 12

Connect the water hose to the water faucet of the water main supply system
The supplied water quick-connector must be
screwed to a faucet; remove the clipper from the
water quick-connector, insert the other end of the
water hose into this quick-connector port com-
pletely, install back the clipper.
Step 1: Qucik-connector and the
water faucet
Operation the ice-making process
1. After all of the water pipe connecting is complet-
ed, plug in the main power supply. Then press
" " button on the control panel to begin the
ice making cycle, and the"Ice"light will be on
at same time. The digit window will display the
ambient temperature normally. The compressor,
fan motor and water pump will run during ice
EN
making process.
2. Each ice making cycle will last about 11 to 30
minutes, depending on the ambient temperature
and the water temperature.
3. When the ice-making process is over the ma-
chine will switch to ice-harvest process. At
same time the system will detect the water lev-
el, if the water level is lower than required, "Add
water"light starts flashing, open the water inlet
valve to supply extra water to water tank, when
the water supplying process is finished, the "Add
water" light is off again.
Automatic self-cleaning program
Start the self-cleaning program: After connecting
all of the water pipe, plug on the main power supply
plug press the " " button for more than 5 seconds,
this starts the cleaning program. The "Clean" light
will be on during cleaning, the digit window will
indicate the left time. The self-cleaning program
takes 30 minutes.
12
Step 2: Screw the qucik-con-
nector on the water faucrt by
the screw thread, and remove
the clipper
Remove the
clipper first
Important: The water pressure of main water sup-
ply system must be 0.04-05 MPa at.
Step 3: Insert the water hose
completely
Push inwards
4. When the "Full " indicator is on, the unit stops
running. If you remove enough cubes, the unit
will start to work again after a 3 minute period.
5. During the ice-making process, press the
button to adjust the ice-making process du-
ration period length, this will change the thick-
ness of the ice cube. The default setting is zero,
1 minute will add or decrease to the process per
pressing of the
the last press, the new setting are programmed.
6. Bad water quality will cause bad quality of ice
cubes and will reduce the transparency of the
ice cube.
NOTE: Created ice cubes are joined together and
still need to be broken apart.
Cancel the self-cleaning program: It takes about
30 minutes to complete one self-cleaning program.
When the program is over, the system will be in off-
state automatically. And also you can press the " "
button on control panel to cancel the self-cleaning
program by force.
Step 4: Insert back the clipper
or button. 5 seconds after
or