Interior Cleaning - Hendi Arktic 271575 Mode D'emploi

Interior Cleaning

For Ice Storage Bin
The ice storage bin should be sanitized occasion-
ally. Clean the bin before the ice maker is used
for the first time and reused after stopping for an
extended period of time. It is usually convenient to
sanitize the bin after the outside, the storage bin
must be empty.
1. Disconnect power to the unit.
2. Open the door and with a clean cloth, wipe down
the interior with a sanitizing solution made of
28g of household bleach or chlorine and 7.5L of
hot water.
Ice Making Parts Cleaning
During the using, periodically to clean these main
system of your ice-maker.
1. Repeat above step to clean the water tank and
other inner parts of the unit.
2. Clean the water dividing pipe on the evaporator
extra, uninstall this part and clean each little
hole displayed in the following illustration, make
sure each hole is not clogged, then install back
to the original location.
3. When there are ice cubes on the surface of the
evaporator, but they can't fall, don't remove it by
force; just press the " " button for more than
5 seconds, the unit will enter the ice melting
process. After some while the big ice-cubes will
fall down. Turn off the unit and unplug the power
cord to clean the surface of the evaporator.
Water
dividing pipe
Evaporator
Little holes of water dividing pipe
Pull up
first
Then move out
right toward
3. Rinse thoroughly with clear water. The waste
water will be drained out through the drain pipe.
4. Reconnect power to the unit.
The ice scoop should be washed regularly. Wash it
just like any other food container.
WARNING: Do not use solvent-based or abrasive
cleaners. These may transmit taste to the ice
cubes.
4. For the water tank and ice-full detecting plate.
Also the water tank and the ice-full detecting plate
is very important to keep your ice cube hygienic.
Put mixture of neutral cleaner & water into a clean
water jet, then spray to all the inner surface of tank
& the ice detecting plate. Wipe these surfaces as
far as possible with a clean cloth. And then, spray
the surfaces with clean water, wiping with a dry
clean cloth. Then drain out the cleaned water in the
water tank by pulling out the Water drain pipe of
the water tank indicating (H in illustration). When
all of the cleaned water has been drained out, re-
install back the water drain pipe of the water tank.
Suggestion: After cleaning the interior parts dis-
card the first batch of ice.
EN
Ice-full detecting plate
Water tank
15