Elite REALPOWER Mode D'emploi page 30

• Make sure the lever of the quick release is
inside the grooves of the left bushing pin (FF)
(fig. 24).
• If the wheel is too far away with respect to the
middle of the roller (fig. 25), shift the resistance
unit (B) by loosening the unit fixing screws (P) and
secure them in the more correct position (fig. 26
and 27).
24
• Tighten the adjustment screw (Ref. V) on the
support plate until the roller touches the wheel
(fig. 28).
25
THEN ROTATE THE ADJUSTMENT SCREW BY
THREE TURNS IN ORDER TO OBTAIN THE
CORRECT PRESSURE OF THE ROLLER ON THE
WHEEL.
If the wheel slips while you are pedalling, rotate
the adjustment screw by another complete turn.
• Check the stability of the bicycle by pulling and
pushing the top tube of the frame and the saddle.
If the bicycle is not stable, make sure the quick
release and its lever are correctly positioned, that
the lever (HH) is in the "close" position and the
clamping system adjustment has been correctly
carried out (fig.14/15).
26
EN
27
28
29