Connecting The Inverter - Dometic PERFECTPOWER PP 1002 Instructions De Montage Et De Service

PerfectPower
• Select a well-ventilated location for the device.
A ventilation system must be present for installations in small, enclosed spaces.
• Make sure that the air intake on the front of the inverter remains clear.
• Select a mounting surface which is flat and sufficiently firm.
Fasten the inverter as follows (fig. 5, page 4):
A
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Clip two holders on the left bar and two on the lower right bar.
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the holder.
8.2

Connecting the inverter

!
WARNING!
The inverter may only be connected by a qualified workshop.
The following information is intended for specialists who are familiar with
the guidelines and safety precautions to be applied.
Observe the following safety instructions for the electrical connections:
A
NOTICE!
• Caution – Risk of short circuit!
When working on the vehicle, always disconnect the earth
connection to the supply battery.
• Disconnect the 230 V external power supply to the caravan.
• If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
• Do not lay cables which are loose or bent next to electrically
conductive material (metal).
• Fasten the cables securely.
• Do not pull on the cables.
• Do not lay the 230 V mains cable and the 12/24 V DC cable in the
same duct.
• Lay the cables so that they cannot be tripped over or damaged.
EN
Fastening and connecting the inverter
13