Connecting The Inverter - Dometic WAECO SinePower MSP 162 Instructions De Montage Et De Service

SinePower
7

Connecting the inverter

Caution
a
The cable between the battery and the inverter may not exceed a
maximum length of 2 m.
7.1 Connecting the MSP 162 and MSP 164
The connection is made via a plug that is connected to a 12 V vehicle socket
(for MSP 162) and a 24 V vehicle socket (for MSP 164).
The middle pin of the plug must be connected to the positive wire (fig. 1 6,
page 3) and the two side brackets of the plug must be connected to the neg-
ative wire (fig. 1 7, page 3).
Caution
a
Make sure that the plug is firmly connected in the vehicle socket. If
the connection is loose, the plug may heat up.
Caution
e
The rating of the vehicle socket, the supply cable, and the fuse
must be at least 15 amps. Do not put in a fuse with a higher rating.
7.2 Connecting the MSP 352 and MSP 354
Warning
e
Never use the inverter on vehicles where the positive terminal of
the battery is connected to the chassis.
Connect the inverter to the chassis or earth.
Only use copper cables.
Keep the cables as short as possible.
Fit a 50 A cable fuse in the positive cable as close to the vehicle battery
as possible.
EN
Connecting the inverter
27