Dometic WAECO SinePower MSP 162 Instructions De Montage Et De Service page 23

SinePower
2.2 Safety when installing the device
Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
Take the precautions necessary to ensure that children cannot interfere
with operation. Dangerous situations may occur which cannot be recog-
nised by children!
Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
Electrical cables
If cables have to be fed through metal walls or other walls with sharp edg-
es, use ducts or wire bushings to prevent damage.
Do not lay cables which are loose or bent next to electrically conductive
material (metal).
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in the same
duct.
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
2.3 Operating the appliance safely
Operate the device only if you are certain that the housing and the cables
are undamaged.
Make sure the air inlets and outlets of the device are not covered.
Ensure good ventilation.
Do not connect the 230 V output of the inverter (fig. 1 3, page 3) to a
different 230 V source.
Even after the fuse triggers, parts of the inverter remain live.
Always disconnect the power supply when working on the device.
EN
Safety instructions
23