Philips Saeco Xelsis SM7583 Mode D'emploi page 19

Problem
I cannot activate the
AquaClean filter and the
machine asks for
descaling.
The new water filter does
not fit.
The machine is making a
noise.
Cause
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
The machine is not placed on a
horizontal surface.
The filter has not been replaced
in time after the AquaClean
filter icon flashed and the
capacity dropped to 0%.
You did not install the
AquaClean filter during first
installation, but after having
brewed approx. 25 coffees
(based on 100ml/3oz cups). The
machine has to be completely
limescale-free before you
install the AquaClean filter.
You are trying to install another
filter than the AquaClean filter.
It is normal that your machine
makes noise during use.
The AquaClean filter was not
prepared properly and air is
now drawn into the machine.
Solution
Empty the drip tray every day or as
soon as the 'drip tray full' indicator pops
up through the drip tray cover (Fig. 25).
Place a cup under the dispensing spout
to collect rinsing water.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.
Descale your machine first and then
install the AquaClean filter.
First descale the machine and then
install a new AquaClean filter. After
descaling, the filter counter is reset to
0/8. Always confirm filter activation in
the machine menu. Also do this after
filter replacement.
Only the AquaClean filter fits into the
machine.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').
Remove the AquaClean filter from the
water tank. Shake the filter for about 5
seconds. Immerse the filter upside
down in a jug with cold water for at
least 30 seconds. Wait until no more air
bubbles come out. Place the prepared
AquaClean filter back into the water
tank. Then dispense 2-3 cups of hot
water.
English
19