Operation - Dometic MASTERFLUSH MF 7100 Notice D'utilisation

6 Toilet Operation
Caution
Do not operate toilet without water supply turned on. Damage to internal components
may occur.
Freshwater Flush
6.1
6.1.1 Toilet system start-up
1. Turn on fresh water supply to toilet.
2. Press "Flush" switch (2) and hold for at least 10 seconds.
3. Toss several sheets of toilet paper into bowl and repeat cycle.
The bowl should completely clear.
6.1.2 Normal flushing
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (1) until desired water level is achieved. (Do not press "Add Water" switch
FLUSHING TOILET
Press "Flush" switch (2) down and hold until waste drains from toilet bowl (about 10 – 20 seconds).
This switch activates a macerator pump that siphons water and waste from the bowl, macerates,
Freshwater Flush
6.2
6.2.1 Toilet system start-up
1. Turn on fresh water supply to toilet.
2. Press "Flush" switch (2) and hold for at least 10 seconds.
3. Toss several sheets of toilet paper into bowl and repeat
cycle. The bowl should completely clear.
6.2.2 Normal toilet operation
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (1) and hold until desired water level
is achieved. (Do not press "Add Water" switch too long or
FLUSHING TOILET
Press "Flush" switch (2) down and hold until waste drains from
toilet bowl (about 10 – 20 seconds). This switch activates a macerator pump that siphons water and
"DRY BOWL" OPERATION
During periods of rough travel, water in a toilet bowl can splash out and into the bathroom area. To
avoid this situation, press "Dry Bowl" switch (3) to drain water completely from toilet bowl. Water is not
added to bowl during or after pressing the "Dry Bowl" switch.
(with DFS-2F switch)
(toilet with DFST switch)
Dometic MasterFlush
1
2
2 1
3
7