Mantis 401739 Manuel D'utilisation page 8

Assembly
How to assemble upper
handles and carrying
handle
1. Lightly squeeze the lower
handles (no. 6) toward one
another so that they line up with
the two smaller holes on the
carrying handle (no. 42). Then
slide the carrying handle over and
down the lower handles. It will
rest about 10 to 15 cm above the
fender. (Picture 1)
2. Gently pull the lower handles
out to their original position.
3. Attach the upper handle
assembly (no. 1) – the handle with
the throttle cable and ground wire
– onto the right lower handle, and
secure with the handle knob (no.
53). (Picture 2 and 3)
Picture 1
Picture 2
8
(continued)
Note: If throttle handle is
mounted on the left, it will not
fold down as completely as when
mounted on the right.)
Be sure you have proper throttle
movements and that the throttle
cable is not wrapped or twisted
around the handle bar. Squeeze
trigger and let go.
THIS MUST BE DONE
BEFORE STARTING THE
ENGINE.
4. Follow the same steps to
install the other upper handle onto
the other lower handle. (Picture 3)
5. Use the clip (no. 13) to
secure the throttle cable and wire
in place on the lower handle.
(Picture 4)
6. Now install the handle brace.
WARNING:
!
!
REMOVE TINES BEFORE STARTING ENGINE
Picture 3
Improper throttle installation can cause
tines to rotate unexpectedly .
WARNING • DANGER
AND MAKING ADJUSTMENTS.
Picture 4
Line it up with the holes on the
upper handles. Then insert a cap
screw and a lock nut on either
side (Picture 5)
7. Use a spanner/wrench to
tighten cap screws and lock nuts.
8. Now use spanner/wrench to
tighten all nuts and bolts firmly
and securely.
IMPORTANT NOTE:
Make sure you have installed
the handles properly. When you
stand behind your tiller, holding
the handles, the fuel tank is
facing away from you, on the
front side of the engine.
!
Picture 5