Cassese MACH 5 Mode D'emploi page 49

USER MANUAL MACH 5 CART
The distributor is full of grease.
>Perform the procedure described in chapter 7.C REMOVING THE DISTRIBUTOR HEAD (page 43) and remove any excess grease.
Do some stapling in scrap mouldings to purge any excess. Then wipe off the top of the distribution head.
The corners are crooked.
>Make sure to place the first moulding against stop
>Make sure that clamping pressure is sufficient. Use the «clamp pressure» regulator on side of the machine to adjust it see
chapter 4.J USE OF REGULATOR (page 30).
49