Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
Press this button to
search the article in
the memory of the
machine.
4.D ADVANCED SCREEN: PREPARING THE EXECUTION
Once the parameters are set correctly ( chapter 4.A ADVANCED SCREEN: PROGRAMMING A PROFILE), you can then configure the
execution.
4.D.a
Select the mode you would like to use for stapling. Press AUTO or MANU. The selected
mode will turn in black background.
MANUAL MODE : this mode will require two actions to get the corner done. Pressing
the pedal will engage the front clamps to keep both mouldings together. You can then
check the joining before launching the stapling with the stapling button. Manual mode
will be selected by default at each power up of the machine.
AUTO MODE: this is the quickest mode, the machine will engage the front clamps and
staple immediately when the pedal will be pressed.
4.D.b
The vertical clamp speed can be adjusted depending on the hardness of the wood.
Using that button will set the speed of the vertical clamp. Press that button to select
turtle or rabbit mode.
TURTLE MODE : this mode will select a slower speed for the vertical clamp, it is useful
for very soft moulding.
RABBIT MODE: Most of the time this mode will not cause any damage to the moulding
and can be used to save time.
Figure 4-17
Selecting the stapling mode
Selecting the speed
The
machine
will
display
the
various
accessories to be used,
in this example:
-green round clamp
-5mm wedges
-squareframe
-spacer
bars
are
needed.
Once the accessories
have
been
installed
accordingly,
press
execute
button
to
confirm.
MACH 5 CART
Figure 4-18
Figure 4-19
Figure 4-20
24
Publicité
Table des Matières
