Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
Touch several times
QTY to select
the
amount of wedges to
be inserted in the
current
position.
Number of wedges is
just on right side of
the button.
Use the arrows to get
the head moving to
the desired position.
4.G
SIMPLE SCREEN: MEMORISING A PROFILE
After having proceeded to the programming of the machine ( refer to chapter 4.F SIMPLE SCREEN: PROGRAMMING A PROFILE
page 26 ), it is possible to memorize the profile so it can be executed next time without having to program it again. This can't be
done from the simple screen, but it can be done from advanced screen, even if the programming was done from the simple
screen.
The simple and advanced screen are linked together, any modification in one screen will affect the
other one, so you can swap at any moment from simple to advanced screen without loosing your
parameters.
Press the main menu
button.
When levelling the machine, if the machine is installed against a working table, make sure a long
frame will not be risen up by the table, this would cause bad joining.
Repeat
procedure
Figure
6-25
for
positions.
Instead of measuring
the
position
entering it with the
keypad, it is possible
to move the shooting
head step by step to
the desired position.
Figure 4-28
It is also possible to
go
directly
desired position by
touching the position
number. A keypad
will
allow
select
directly
position.
Figure 4-30
Then
press
ADVANCED
or STANDARD button
to
return
simple screen.
Figure 4-32
same
from
4-24Figure
other
and
at
a
you
to
the
the
button
to
the
MACH 5 CART
Figure 4-29
Figure 4-31
Figure 4-33
27
Publicité
Table des Matières
