Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
If a second position
is needed, touch the
number correspond
-ing to the position to
be programmed and
proceed in the same
way to enter
the
desired values.
4.B ADVANCED SCREEN: MEMORISING A PROFILE
After having proceeded to the programming of the machine ( refer to chapter 4.A ADVANCED SCREEN: PROGRAMMING A
PROFILE page 21), it is possible to memorize the profile so it can be executed next time without having to program it again. Some
extra parameters can also be set to ensure the operator is using proper accessories.
If
the
frame
is
octagonal
or
hexagonal type, then
touch the 45° button
several times until
the right angle is set.
If
you
wish
to
memorize the type of
top
clamp
to
be
used,
touch
that
button several times
until the correct top
clamp is displayed.
Instead of measuring
the
position
entering it with the
keypad, it is possible to
move
the
head step by step to
the required position.
This allows to check
immediately that the
position of the top
clamp will be steady.
Use the two arrows to
Figure 4-6
move the head in one
way or the other until
you reach the required
position.
If
the
should
spacer bars, touch
the spacers button
several
achieve
setting.
Refer to chapter I.3.E
SPECIFIC USE OF THE
SPACER BARS (page
18) to know when
use
of
Figure 4-8
recommanded.
Select
the
size
of
proceeding the same
way.
Figure 4-10
and
shooting
operator
use
the
times
to
the
right
spacer
is
correct
wedge
MACH 5 CART
Figure 4-7
Figure 4-9
Figure 4-11
22
Publicité
Table des Matières
