Setting Date And Time; Choosing The Favorite Execution Screen; Overriding Wedge Sensor; Reading The Statistics - Cassese MACH 5 Mode D'emploi

USER MANUAL
6.B.d
Press this button to
set date/time.
The machine will ask
for a code, enter the
code 9059.
A keypad will come
ON to allow you to
enter your
parameters.
6.B.e
When the machine is started up, the welcome screen will appear. Changing that option
will make the machine going in simple screen immediately (select MODE STAND.) or in
advanced screen immediately (select MODE MODE ADVANCE) when you will touch the
welcome screen at power up .
The machine will ask for a code, enter the code 9059. Once the setting is done, turn off
the machine to lock back the parameters.
6.B.f
In case the wedge sensor is causing problems, it is possible to deactivate it (machine will not detect anymore the end of the
cartridge).
Change OPTICAL
FIBRE to NO NAIL
SENSOR .
You will be asked for
the code 9059.
6.B.g
The machine is measuring permanently the time spent to make a corner to display
the following statistics:
SEC/C: measures how long it took to make the last cycle (in seconds).
C/MIN: tells how many cycles of the last job could be done in a minute.
C/HOUR: tells how many cycles of the last job could be done in a hour.
C/LAST MIN: measure how many cycles where done in the last minute.
C/H LAST MIN: measure how many cycles where done in the last minute.
You can also have access to the following:
COUNTER NAILS: amount of nails shoot by the machine since it was build.
COUNTER CYC: amount of corners done by the machine since it was build.
Page 3/7: setting date and time
Figure 6-15
Page 3/7: choosing the favorite execution screen
Page 3/7: overriding wedge sensor:
Figure 6-18
Page 3/7: reading the statistics
Use arrows to select
the data to modify,
then + or – to change
the setting.
Press SAVE button
before to QUIT.
Once the setting is
done, turn off the
machine to lock back
the parameters.
Make sure this
parameter is also set
to NO NAIL SENSOR.
Once the setting is
done, turn off the
machine to lock back
the parameters.
MACH 5 CART
Figure 6-16
Figure 6-17
Figure 6-19
Figure 6-20
35