B Maintenance Plan; Daily Maintenance; Regular Maintenance - Cassese MACH 5 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USER MANUAL
7 MAINTENANCE
7.A SAFETY INSTRUCTIONS
The MACH 5 CART is using two types of power sources: electric and pneumatic. It is essential for your safety
to make sure that both of them are disconnected prior to make any maintenance. Please refer to instructions
below prior performing any maintenance.
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It
Unplug the machine
should be installed in a dry environment providing temperate temperature. The floor should be flat and
from the electrical
clean. Select a location with proper lighting in the joining area.
supply
If using compressed air to clean some parts, wear safety glasses. It is even recommended to use a vacuum to

7.B MAINTENANCE PLAN

7.B.a
It is recommended once a day to clean the table surface with a clean cloth and make sure there is no debris in the distributor
head. If some glue is remaining in the distribution block, then perform procedure 7.C REMOVING THE DISTRIBUTOR HEAD (page
43) and 7.D LUBRICATING THE DISTRIBUTOR HEAD (page 44). It is important to avoid glue from drying in the distribution head
as it could prevent the cartridge from going in the distribution block correctly.
7.B.b
Every 50 000 inserted wedges, the machine will ask for a maintenance a warning screen will come up asking you to lubricate the
distribution head. Refer to following chapter to perform this maintenance:
7.A
SAFETY INSTRUCTIONS
7.C REMOVING THE DISTRIBUTOR HEAD (page 43)
7.D LUBRICATING THE DISTRIBUTOR HEAD (page 44)
7.F RESETTING THE MAINTENANCE ALARM (page 45)
Figure 7-1
clean the machine rather than compressed air that will spray dust everywhere.
All maintenance and control operations must be carried out by skilled maintenance staff.

Daily maintenance:

Regular maintenance:

(page: 42)
Rotate red button in
EXH position.
Unplug the machine
from
pneumatic
source.
Install a locker to
ensure nobody will
turn back on the
machine while you
will be performing
the maintenance.
MACH 5 CART
Figure 7-2
42

Publicité

Table des Matières
loading

Table des Matières