Resetting The Counter; Eadvanced Screen: Review Of All Buttons - Cassese MACH 5 Mode D'emploi

USER MANUAL
4.D.c
Pressing this button will help to set the counter, a keypad will appear allowing to reset it
or to set it to a certain number.
If you set it at zero when starting production, you will see it increasing at each cycle so
you know how many cycles were done. You can also configure it so it will decrease.
Then entering the amount to be done in this field will allow you to see the remaining
cycles to be done.
This counter can be set so it counts frames or corners.
Refer to chapter I.6.B.b Page 2/7: counter configuration (page 34) for configuration of
that counter.
4.E ADVANCED SCREEN: REVIEW OF ALL BUTTONS
This screen will display the 9 positions in only one page, each position has a dedicated box labelled with its position number. No
need to navigate in different pages to see the various positions programmed.
Alarm messages
Joining angle (if
different from 45°,
8
you will need
optional spacers).
Position in
millimeters
8
Position number
8
Quantity of Vnails
8
Quantity of cycles
8
done
Reference of the
profiles
8
8

Resetting the counter

To indicate if operator needs
to introduce the spacer bars
8
Manual Automatic
mode mode
8
To search for a To indicate the type of
reference vertical clamp to be used.
8
Clear all the positions
8
8
MACH 5 CART
Figure 4-21
Return to main
menu
8
Size of Vnails to be
used
8
Moulding width
8
Fine tuning
table position
8
Record profile
button
8
Move head
forward.
8
Move head
backward.
8
Select stapling speed
8
8
of
25