Aair Line Fittings; Bconnecting To The Air Source - Cassese MACH 5 Mode D'emploi

USER MANUAL
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It
should be installed in a dry environment providing temperate temperature. The floor should be flat and
clean. Select a location with proper lighting.
2.A AIR LINE FITTINGS
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It
should be installed in a dry environment providing temperate temperature. The floor should be flat and
clean. Select a location with proper lighting in the joining area.
Female quick
connector
Z749
Quick
release(Q/R)
Female
Air Connector
- Z749
2.B CONNECTING TO THE AIR SOURCE
The machine should be connected to a pneumatic circuit providing 6 to 8 bars pressure.
Connect the machine
using the quick
connectors as
mentioned in
chapter I.2.A
The red knob in Figure 2-8 can be used to secure the machine during maintenance or to prevent non desired
use. A lock can be applied to it in stop position so nobody can turn it back to ON. This will exhaust air from
the machine circuit and disconnect it from air supply, but it WILL NOT switch off electrical components. Refer
to chapter I.7.A
machine
standard
connector
USA male quick connector - Z701
Figure 2-7
SAFETY INSTRUCTIONS (page 42) for further instructions.
- Z556
The MACH 5 CART
must be connected
to the air source
located on the front
panel of the drawer.
Turn the compressed
air valve to ON by
rotating its red knob.
The air pressure
gauge should show 6
bars (85 p.s.i.)
minimum.
The MACH 4 CART
must be connected
to the air source
located on the front
panel of the drawer.
Turn the compressed
air valve to ON by
rotating its red knob
(1).
Supplied by the customer
MACH 5 CART
Figure 2-8
13