Gadjusting The Joining Angle; Hmeans Of Joining - Cassese MACH 5 Mode D'emploi

USER MANUAL
3.G ADJUSTING THE JOINING ANGLE
If the corner is
opened towards
outside
If the corner is
opened towards
inside.
If you get this result : it means your cutting angle is less than 45°.
Your cutting machine needs to be set to the right 45° angle (check your cutting
machine's user manual to make this adjustment).
3.H MEANS OF JOINING
Thanks to the color code, you can recognize and select easily the type of Vnails to be
used. Please note that hard wood Vnails will have a yellow pusher to help identifying
them. A white pusher will indicate soft wood Vnails.
See color chart bellow for identification.
Cassese wedges can also be supplied in MDF type dedicated to MDF or very hard wood
use. Tey are identified by a red pusher ine the cartridge.Please contact your local agent
to try them.
Tighten
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the angle
clamping the corner
against
fences again.
Figure 3-25
Loosen
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the angle
clamping the corner
against
fences again.
Figure 3-27
the
to
by
the back
the
to
by
the back
MACH 5 CART
Figure 3-26
Figure 3-28
Figure 3-29
Figure 3-30
19