Dometic CoolAir SP950C Instructions De Montage page 8

Guarantee
Fit the fastening frame and the condenser at the Scania NG 2017 as follows:
➤ Insert and tighten the four M8 x 30 bolts, eight U washers M8 8.4 x 16 mm and
four M8 retaining nuts (fig. 1, page 3) in the mounting frame for the condenser
unit.
➤ Push the U washers onto the threaded pins up to the M8 nuts (fig. 2 1, page 4).
➤ Fasten the fastening frame using the U washers and M8 retaining bolts provided
(fig. 2 1, page 4).
➤ Place the condenser unit on the projecting bolts of the mounting frame and bolt
to the four U washers M8 8.4 x 16 mm and four M8 retaining nuts.
➤ Check that all bolts are still tight after travelling approximately 200 km.
6 Guarantee
The statutory warranty period applies. If the product is defective, please contact the
service partner in your country (addresses on the back on the instruction manual).
Our experts will be happy to help you and will discuss the warranty process with you
in more detail.
8
CoolAir SP950C, SPX1200C
EN