Technical Data; Mounting - Maico EVN 15 Instructions De Montage Et Mode D'emploi

8. Technical data

For technical data,  the rating plate.
For characteristic curves,  catalogue or
Internet.
Nominal size
Air volume
Degree of protection
Rated voltage
Power frequency
Nominal power
Weight

9. Mounting

WARNING
Danger of injury due to cuts caused by
glass breakage, if the windowpane is
under stress. Only install the windowpane
so that the glass is not under stress. If
necessary, remove the windowpane and re-
fit it so that it is not under stress.
NOTICE
Shutter does not close properly, if it is
tensely installed. Only mount the shutter
on a level surface in order to guarantee the
shutter function.
150 mm
240 m³/h
IP 24
230 VAC
50 Hz
25 W
1.6 kg
① Inside
② Window
③ Window
cut-out:
Min. Ø 184,
max. Ø 195
④ Lamellae open
+ 15 mm
8. Technical data │ UK
● Make sure there is sufficient space to the
window frame, wall or ceiling.
● Never dismantle the shutter.
Fig. A:
Installation preparations
1. Lay power cable.
2. Get an expert to make the window cut-out
[S]. Drill the cut-out [S] in the case of
wall/wooden panel installation.
3. Clean the windowpane thoroughly before
adhesively bonding the shutter on.
Fig. B:
Disassembling the inner part
1. To do this, hold the internal housing [3]
firmly at the side and pull the connecting
flange [2] at the motor out of the cover.
2. Remove the terminal box cover [4].
In case of wall/wooden panel installation:
3. If necessary drill through the connecting
flange [2] on the 2 knockout points [X]
( Fig. B).
4. Drill through the 4 knockout points [Y]
( Fig. B1) on the shutter, with the
lamellae open.
Fig. C/Fig. C1:
Installing the shutter [1] (outside).
1. Insert the screws [5] into the eyes of the
shutter until they snap into place.
2. Remove the protective foil from the gluing
points [7].
3. Align the shutter in the window cut-out and
press it onto the pane.
In case of wall/wooden panel installation:
4. Attach the shutter [1] to the wall or wooden
panel with suitable mounting material.
Fig. D:
Installing the inner part (inside)
CAUTION
Danger of injury due to cuts caused by
glass breakage, if the nuts have been
over-tightened. Tighten the lock nuts [8]
carefully making sure not to over-tighten them.
13