Intended Use; Predictable Misuse; Environmental Conditions And Operating Limits; Technical Data - Maico AKE 100 Notice De Montage Et Mode D'emploi

3.3 Intended use

● The unit is only intended for domestic use
and similar purposes.
● The unit serves to dehumidify cellars,
storage rooms, showrooms, offices,
changing rooms and similar rooms up to a
floor area of approximately 25 m
● Operation is only permitted with:
● a fixed installation within buildings.
● installation on walls or ceilings.
● an air supply via shaft or duct.
● electrical flush-mounted connections.
Full functionality is only achieved
with the delivered external climate
sensor (external shutter with
integrated external climate sensor).
Limited use in case of
NOTICE
structural defects.
In the case of structural defects,
water often enters the cellar
through floors and ceilings.
In such cases, the AKE 100
ventilation system can be
additionally be used for cellar
dehumidification. The unit helps
to dry out walls via a controlled
air exchange. It can not be used
independently to achieve
complete dehumidification.

3.4 Predictable misuse

Maico is not liable for damages caused by
improper use (use other than intended use).
Under no circumstances should the unit
be used:
● in single air extraction systems according
to DIN 18017-3.
● close to flammable materials, liquids or
gases,
● for conveying chemicals, aggressive gases
or vapours,
● in potentially explosive atmospheres,
● outdoors.
4. Environmental conditions and
operating limits
● Permissible maximum temperature of air
medium + 40 °C.
● Sufficient supply air intake must be
ensured during operation with air-ventilated
2
.
fireplaces.
The maximum permitted pressure
difference per living unit is 4 Pa.

5. Technical data

See rating plate or Internet.

6. Safety instructions

General
● Assembly and electrical
connection may only be
undertaken by electricians in
accordance with chapter 1.
● Read these operating
instructions carefully before
commissioning.
● Only connect unit to
permanently wired electrical
installations with NYM-O or
NYM-J (3 x 1.5 mm² or 5 x 1.5
mm²) cables. Mains isolation
device required with contact
openings of at least 3 mm at
each pole.
● The unit may only be operated
using the voltage and
frequency shown on the rating
plate.
3. Product information │ UK
15