Switching On - Stihl HSE 61 Notice D'emploi

English
Make a loop (3) in the extension
N
cord.
Pass the loop (3) through the
N
opening (4).
Slip the loop (3) over the hook (5)
N
and pull it tight.
Connect the extension cord plug to
N
a properly installed wall outlet.
30

Switching On

Make sure you have a secure and
N
balanced footing.
Stand upright – hold the power tool
N
3 in a relaxed position.
Make sure the cutting attachment is
5 N
4
not touching the ground or any other
objects.
Hold the unit with both hands – one
N
hand on the control handle – one
hand on the loop handle.
Push the switch lever (1) against
N
the loop handle and hold it there.
Push down the trigger switch
N
lockout (2), depress the trigger
switch (3) and hold them in that
position.
The machine is designed for two-hand
operation, i.e. it will run only when the
operator's hands are on the switch
lever (1) and trigger switch (3).
2
1
3
To extend reach
2
4
3
Hold the power tool with both hands
N
– one hand on the control handle –
one hand on the auxiliary switch at
the rear end of the control handle.
Operate the auxiliary switch (4) and
N
hold it in that position.
Push down the trigger switch
N
lockout (2), depress the trigger
switch (3) and hold them in that
position.
The machine is designed for two-hand
operation, i.e. it will run only when the
operator's hands are on the auxiliary
switch (4) and trigger switch (3).
HSE 61, HSE 71, HSE 81