Settings For Each Temperature Zone; Displaying The Set Temperature; Setting The Temperature; Switching The Fan On/Off (Dynamic Cooling Mode Or Silent Mode) - Dometic B29G Instructions De Montage Et De Service

Wine Refrigerators

7.7 Settings for each temperature zone

The temperature of each temperature zone can be set between 5 °C and 20 °C (41 °F and 68 °F).
If your wine refrigerator has two temperature zones, there are up and down buttons for each zone (fig.
12). In this case make the following settings seperately for each zone by using the corresponding up button
button .
NOTE:
• If the temperature zones are one above the other, the temperature for the lower zone must always be just as high
or higher than the temperature for the upper zone .
• The appliance functions at its best if the difference in temperature between the two zones is at least 4 °C (39 °F).

7.7.1 Displaying the set temperature

NOTE:
When using the appliance for the first time or if it has not been used for a long time, the inner temperature
could differ from the one you have set. The temperature display flashes as long as this is the case. Once the set
temperature has been reached, the temperature display lights up constantly.
1. Press the up button or the down button
The display shows the set temperature.
9
After 5 seconds the display shows the current inner temperature again.
9

7.7.2 Setting the temperature

1. Display the set temperature by briefly pressing the up button
2. Briefly press the up button
3. Briefly press the down button
The display flashes while you make the setting.
9
Once you have set the temperature, the display shows the current inner temperature again.
9

7.7.3 Switching the fan on/off (dynamic cooling mode or silent mode)

The fan can be operated in two different modes:
• Silent mode: The fan runs only when required. It switches off when the set temperature is reached.
• Dynamic cooling mode: The fan runs permanently to regulate humidity and temperature. This way an homogeneous cli-
mate for the interior of a temperature zone is reached.
1. Press the down button
Five acoustic signals are emitted.
9
The fan is switched to dynamic cooling mode.
9
2. Press the up button for at least 5 seconds.
Three acoustic signals are emitted.
9
The fan is switched to silent mode.
9

7.8 Temperature monitoring

A warning signal sounds and the temperature display flashes in the following cases:
• the inner temperature of a zone deviates from the set temperature by more than 5 °C
• the power supply has been disconnected for a long time
• the door has not been shut properly
• the door is open for more than 60 seconds
This prevents the temperature from falling or rising too much unnoticed, which could affect the quality of the wine. Once the
unit has reached the set temperature, the warning signal stops and the temperature display stops flashing.
To switch off the warning signal prematurely:
1. Press the on/off button
The temperature display flashes until the set temperature is reached. The display is then illuminated constantly and indi-
9
cates that the alarm system is active again.
EN
briefly.
to increase the temperature.
to decrease the temperature.
for at least 5 seconds.
briefly.
or the down button
4445103123
Operation
and , on page
and down
.
21