Adjusting The Ventilation Grille; Electrical Connection; Integrating Appliances; Installing Built-In Models (E18Fgb, E49Fgb) - Dometic B29G Instructions De Montage Et De Service

Mounting and connecting

6.7 Adjusting the ventilation grille

1. Adjust the height of the ventilation grill (fig.

6.8 Electrical connection

NOTICE!
• Leave the appliance to stand upright for about 2 hours after transporting, before you connect it to the power
supply. Otherwise this could cause faults in the cooling system.
Observe the following when connecting the appliance:
• Connect the appliance to a circuit that is protected with 15 A.
• Check that the voltage specification on the type plate is the same as that of the power supply.
• Have the socket and power circuit checked by a qualified electrician to ensure that the socket is earthed correctly. Do not
use an extension cable or a multiple power socket.
• The cable must rest securely behind the appliance and not be allowed to lie or hang unprotected.
• Ensure that the power cable is not jammed when pushing the appliance into place.

6.9 Integrating appliances

All free-standing models may as well be integrated either under a worktop between 820 mm and 890 mm in height or be-
tween other cabinets. If you integrate your wine refrigerator, observe the installation dimensions and ensure the door will open
and close properly in the chosen location. Make sure your installation does not block the front ventilation grille.
Note that model E7FG needs at least 30 mm space on the rear side for ventilation (fig.
NOTICE!
If the appliance is fully integrated behind a skirting board:
• Ensure that the ventilation openings in the skirting board have a cross-section of at least 300 cm
• Remove the ventilation grilles, so that warm air can disperse unhindered.

6.10 Installing built-in models (E18FGB, E49FGB)

Observe the installation dimensions (fig.
The appliance is equipped with an integrated ventilation system to disperse the warm air automatically. Air intake is provided
underneath the appliance door and the air escapes at the top of the door.
NOTICE!
The air inlet and outlet must not be covered or blocked in any way.
After installation make sure that the appliance door opens and closes properly.
Secure the appliance inside the cabinet:
1. Open the door.
2. Pop out the two cover caps on the opposite side of the hinge.
3. Tighten the screws through the attachment bracket.
4. Screw the attachment bracket to the inside of the cabinet to secure the appliance in the niche (fig.
18
, on page 6).
, on page 5 and fig. , on page 5).
4445103123
Wine Refrigerators
, on page 5).
.
2
, on page 6).
EN