Installation; Selecting The Installation Location - Dometic C Serie Instructions De Montage Et De Service

Installation

Nr. in
fig. 2,
Symbol Description
page 3
4
5
6
7
8
6 Installation
6.1

Selecting the installation location

Observe the following, when selecting the installation location:
• The ambient temperature should be in accordance with the climate class. Other-
wise, it is possible that the inner temperature you set cannot be reached or main-
tained. This could also be the case if there are extreme fluctuations in the ambient
temperature.
The intended ambient temperature use and the climate class can be found in the
technical data (see chapter "Technical data" on page 32) and on the data plate,
which is located at the left on the inside of the wine cooler.
• The ground must be level and sufficiently stable to support the wine cooler at full
capacity.
• The wine cooler must be positioned so that the plug is accessible.
• Note the information on the electrical connection, see chapter "Connecting the
wine cooler" on page 23.
➤ Remove all the inner and outer packaging material before setting up.
6.2 Integrating free-standing wine coolers
The wine cooler can be integrated either under a countertop or between other cab-
inets (fig. 3, page 4).
Observe the following, when integrating the wine cooler:
• Observe the installation dimensions (fig. 4, page 4).
22
Temperature display (top or left zone)
Temperature display (bottom or right zone)
Increases the set temperature by 1 °C or 1 °F for bottom or right zone
Decreases the set temperature by 1 °C or 1 °F for bottom or right zone
Switches the interior LED lamp on or off
C18B, C46B, D18B, D42B, D46B
EN