Installation Instructions; Important - Cameo OPUS SP5 Manuel D'utilisation

INSTALLATION INSTRUCTIONS

Important!

Replacement of the framing shutter module or the animation wheel module requires detailed specialist knowledge and may
only be carried out by specially trained personnel. If you do not have these qualifications, do not attempt replacement yourself.
Refer instead to a qualified professional.
When interchanging modules, do so very carefully so as to avoid damage to the device and associated components. Follow
each step of the installation instructions exactly. The manufacturer shall not be liable for any damage caused by improper
handling.
1. Fully disconnect the spotlight from the mains (pull out the mains plug)!
2. Place the device head in an upright position and lock it in the vertical plane (tilt-lock).
3. Disassemble the ring-shaped plastic cover (A) on the exit lens of the device head (2 Phillips screws, see arrows). Now remove the head
casing on both sides by turning the 4 quick-release bayonet bolts (B) anti-clockwise (Phillips screwdriver required). The bolts are captive
and cannot be removed from the casing. Make sure you remove the anti-drop safety cable when removing the casing (C).
A
B
The framing shutter module with which the moving head is supplied comprises two components that must be removed from the module
frame in succession (D = framing shutter, E = gobo wheels and colour wheel).
4. At the back of the device head, disconnect the power and signal connectors for both components from the connection terminals (F).
D
E
F
C
5