Technical Maintenance And Repair - Belmash SDM-2000 Instructions D'utilisation Originales

BELMASH SDM-2000, 2200, 2500
11.5.2 Guard mounting
To mount groove cutter guard, do the following:
• remove saw blade guard 2 from riving knife 3 (figure 1);
• assemble vertical holder 6 with vertical holder bracket 36 using thumb screw 12 as
shown in figure 1;
• mount vertical holder 6 into the slot in receiving table and secure it with thumb screw 12.
• mount saw blade guard 2 on vertical holder bracket 36 and secure it with special screw
45 and nut 46;
• set the height of the guard by moving bracket 36 along vertical holder 6.
11.5.3 Milling depth setting
Milling depth is set in the same way as the cutting depth (sub-item 11.2.2).
Milling depth scale 38 is located on the right side of casing 19.
11.6 Clamping device
Clamping device 17 (figures 19, 20) is designed for safe processing of blanks not less than 60
mm thick. Supplied disassembled. Assembling of the clamping device is performed according
to figure 19. To fix the clamping device use the screws 69 and washers 69a.
Figure 20. Clamping device: 18 – spring block, 19 – right support, 20 – left support,
21 – axis of rotation, 65 – clamping axis, 66 – clamp handle, 68 – nut, 68a – spring washer.

12. TECHNICAL MAINTENANCE AND REPAIR

In order to maintain the machine in a permanent technical efficient and working condition, it is
necessary to service the machine each time before using it. It includes the following:
• Performing exterior check;
• Checking the fixing security of slicing blades;
• Cleaning the machine.
The exterior check includes cable test, integrity of security fencing test.
Integrity of cutting tool is inspected visually, and its fastening is inspected using the wrenches
included in package set.
Cleaning includes removing dust, cuttings, wood particles with a brush or a vacuum cleaner
from the machine surface.
12.1 Mounting and adjustment of planing knives
Adjustment is provided by sequential mounting of each knife.
First, release knife 64 by loosening clamping screws 61 to free movement (figure 14) using
hexagon wrench 57.
Adjust the knives 64 by screwing/unscrewing the screws 62 with hexagon wrench 58 so that
the tip of a knife slightly touches straight-edge rule A mounted on planing table 24 (fig. 15).
Secure the knife by tightening clamping screws 61. After final tightening the screws, check the
correctness of knife mounting and, if necessary, repeat knife mounting.
The correctly mounted knives should slightly (up to 0.1 mm) touch the lower edge of straight-
edge rule A (figure 15) with cutting edge when turning cutter block.
EN
29