Intended Use; General Information - Belmash SDM-2000 Instructions D'utilisation Originales

BELMASH SDM-2000, 2200, 2500

2. INTENDED USE

The machine relates to equipment for domestic individual use.
The hand-fed machines are used for processing wood and analogous hard materials
(cardboard, plywood, wood chipboards) by planing, cutting, milling, and drilling in order to
give them the required shapes and sizes.
Do not use the machine for other purposes. It is not allowed to process metals, stone, asbestos-
cement materials, soft plastic, and rubber-like materials.
With appropriate adjustment the machine can perform the following types of processing:
• planing on the surface or along ribs;
• angular planing, along ribs;
• longitudinal and cross-cutting;
• longitudinal angular cutting with the use of a guide;
• angular cross-cutting with the use of the device;
• milling with groove cutters;
• milling with end cutters;
• drilling.

3. GENERAL INFORMATION

The machine can be operated outdoors, under a cover, indoors, except for residential premises.
Climatic service conditions:
• altitude above the sea level – up to 1000 m;
• environment temperature from +5 to +40°С;
• environmental relative humidity – up to 80%, at a temperature of +20°С.
It is not allowed to operate the machine under the impact of drops and splashes, as well as
outdoors during rain, fog, snowfall, strong wing, and storm.
The power of the machine is supplied by a single-phase AC with (earth) wire.
BELMASH SDM-2200 and BELMASH SDM-2500 machines shall be used in the electrical grids
with a nominal impedance z
line rated load capacity is appropriate.
Motor type – asynchronous, single-phase, with the working capacitor, intermittent operating
status – S6-40%.
The equivalent and maximum sound levels are as follows: 80 dBA and 90 dBA relatively.
The machine has a built-in disconnect device from the power supply during engine overheating.
Restarting of the machine can be performed after the electric motor has cooled down to the
ambient temperature.
To connect the external exhaust units in order to collect dust and cutting wastes, the
woodworking machine has three pipes:
• 63 mm on casing for chip removing 33 (fig. 1);
• 38 mm on casing 57 of saw blade 32;
• 28 mm on fencing 2 of saw blade 32.
The external exhaust unit should be suitable for removing cutting wastes.
Operator should make sure that power line rated load capacity is appropriate.
=0,354 ohm. The operator should make sure that the power
max
EN
15