Intended Use; General Information - Belmash SDM-2000 Manuel D'instructions

The machine relates to equipment for the domestic individual use.
The hand-fed machines are used for processing of wood and analogous hard materials
(cardboard, plywood, wood chip boards) by planing, cutting, milling and drilling in order to
give them the required shapes and sizes.
Do not use the machine for other purposes. It is not allowed to process metals, stone,
asbestos-cement materials, soft plastic and rubberlike materials
With appropriate adjustment the machine can perform the following types of processing:
● planing ( jointing) on surface or along ribs;
● angular planing ( jointing, along ribs);
● longitudinal and cross cutting;
● longitudinal angular cutting with the use of a ruler;
● angular cross cutting with the use of device;
● milling with disc cutters;
● milling with end cutters;
● drilling.
The machine can be operated outdoors, under cover, indoors, except for residential premises.
Climatic service conditions:
● altitude above the sea level – up to 1000 m;
● environment temperature from +5 to +40°С;
● environmental relative humidity – up to 80%, at a temperature of +20°С.
It is not allowed to operate the machine under the impact of drops and splashes, as well as
outdoors during rain, fog, snowfall, strong wing, and storm.
The power of the machine is supplied by a single-phase AC with an earthed positive earth.
BELMASH SDM-2200, BELMASH SDM-2500 machines shall be used in the electrical grids
with a nominal impedance z
load capacity is appropriate.
Type of engine – asynchronous, single-phase, with the working capacitor, intermittent
operating status – S6-40%.
The equivalent and maximum sound levels are as follows: 80 dBA and 90 dBA relatively.
The machine has a built-in disconnect device from the power supply during asynchronous
engine overheating. Restarting of the machine can be performed after the electric motor has
cooled down to the ambient temperature.
To connect the external exhaust units in order to collect dust and cutting wastes, the
woodworking machine has three pipes:
● a pipe with 63 mm in diameter on casing for chip removing 33 (Fig. 1);
● a pipe with 38 mm in diameter on casing 57 of saw blade 32;
● a pipe with 28 mm in diameter on fencing 2 of saw blade 32.
The external exhaust unit should be suitable for removing cutting wastes.
Operator should make sure that power line rated load capacity is appropriate.

2. INTENDED USE

3. GENERAL INFORMATION

=0,354 ohm. Operator should make sure that power line rated
max
EN
57