Using The Device - Dometic WAECO PerfectCharge MCA1215 Instructions De Montage Et De Service

Using the device

9 Using the device
➤ Set the On/off switch to "On".
To switch off the device set the On/off switch to "On".
✓ Depending on the charging condition of the battery, the battery charger
starts charging or supplies a retention voltage.
✓ The "Status" LED (fig. 1 5, page 3) displays the operating status (see
following table and chapter "Battery charging function" on page 48).
Display
Orange, quickly flashing
Orange, slowly flashing
Orange, constantly lit
Green, constantly lit
Green, slowly flashing
Red, constantly lit
Red, quickly flashing
Red, slowly flashing
Red, double flash
Red, slow double flash
I
NOTE
In the event of a fault (the Status LED is red), refer to chapter
"Troubleshooting" on page 60).
58
MCA1215 – MCA2440
Meaning
Phase 1
Phase 2
Phase 3
Phase 4
Phase 5
Short circuit or defective fuse
Battery or battery charger is overheat-
ing
Battery undervoltage or overload
Fan fault
Fault at the starter battery connection
EN