Technical Description - Dometic WAECO PerfectCharge MCA1215 Instructions De Montage Et De Service

Technical description

6 Technical description
The low weight and compact construction of the battery charger allow for
easy installation in mobile homes, commercial vehicles or motor and sailing
yachts. It charges batteries that are used on board vehicles or boats to
generate power or supplies them with a retention voltage so that they do not
discharge.
A control lamp on the device enables constant monitoring in the battery
charger.
The device has the following protective systems:
 Short circuit
 Overheating protection
 with sensor (accessory): Battery overheating
The device can also be integrated into a LIN bus using two connections.
The cooling system uses fans whose speed depends on the charging power
and can be switched off using an external switch.
6.1 Device versions
The PerfectCharge MCA battery chargers are available in different versions.
Your MAC battery charger can be used to charge batteries up to a specified
battery capacity (see chapter "Technical data" on page 62):
 MCA1215: suitable for charging one supply battery and one starter
battery
 MCA1225, MCA1235: suitable for charging up to two supply batteries and
one starter battery
 MCA1250, MCA1280: suitable for charging up to three supply batteries
 MCA2415: suitable for charging up to two supply batteries
 MCA2425, MCA2440: suitable for charging up to three supply batteries
For the identification of your device, see the item number on the type plate.
46
MCA1215 – MCA2440
EN