Using The Battery Indicator - Dometic WAECO PerfectCharge BI 01 Instructions De Montage Et De Service

Using the battery indicator

➤ Connect the connection cable to the battery (5) or to the battery charging
points provided in the vehicle.
✓ When the LED display is switched on, the battery indicator displays the
battery capacity (see chapter "Operating elements" on page 24).
7 Using the battery indicator
The battery indicator is switched on and off using the button (fig. 2 5,
page 3). It displays the battery capacity (see chapter "Operating elements"
on page 24).
When it indicates the battery is empty, a MCP04, MCP07 or MCP15
PerfectCharge battery charger can be connected to the battery indicator, and
the battery can be charged directly.
➤ Check that the battery is in good condition.
➤ Check the following:
– The battery housing for damage
– The fluid level in the battery
Fill the battery with the medium specified by the manufacturer, if
necessary.
– The pole contacts
Clean off any dirt present.
Connecting the battery charger (fig. 5, page 5)
!
WARNING!
Observe the operating manual for the battery charger.
➤ Connect the power cable (1) for the battery charger to the 230 V
AC mains.
➤ Connect the battery charger to the plug (2) for the battery indicator.
➤ Start the battery charger.
26
PerfectCharge BI01
EN