Connecting To The Power Supply; Basic Operation; Dab Radio Operation - LENCO SCD-651 Mode D'emploi

Table des Matières

Les langues disponibles

3. CONNECTING TO THE POWER SUPPLY

1. Connect the end of the detachable power cord to the unit rear panel ~AC IN jack and the other end

to the AC outlet.

2. Slide the FUNCTION switch to different modes of operation to turn on the unit.

4. DC CONNECTION

For DC operation, firstly remove the AC plug from the AC outlet and disconnect the AC cord from the

~AC IN jack. Then insert 6 pcs size C (UM-2) batteries into the battery compartment.

Since the unit will draw little power consumption even in OFF mode, it is suggested to uninstall the

battery when it is not used for a long time.

Slide the FUNCTION switch to "FM/DAB" for FM or DAB radio mode. Switch to "CD/USB" for the CD or

USB playback mode. Switch to "AUX" for AUX in mode. To turn off, slide it to the "OFF" position.

Volume Control

Turn the VOLUME CONTROL to change the sound loudness.

Adjusting the Telescopic Antenna

The antenna should be extended to ensure a good FM/DAB radio reception. Alter the antenna position

for the best reception.

1. Slide the FUNCTION switch to "FM/DAB" for DAB radio mode.

2. Press the DAB/FM button will toggle between DAB radio or FM radio mode.

3. For the first time to turn on the unit in DAB mode, it will automatically scan for the available stations.

Wait for a while until the scanning is finished. Display will show the scanning progress bar and the

number of stations found.

Always keep the antenna fully extended for best performance. Try to put your unit near an open window

until you get the best reception.

After scanning it will tune to the first station. The next time the unit is turned on there will be no automatic

Table des Matières