Listening To The Radio - LENCO PPR-100 Mode D'emploi

Listening to the radio

1. Switch the appliance on.
2. Press MODE to select radio mode FM.
Radio playback will begin automatically.
3. Select the station you wish to play by repeatedly
pressing >. Each press of the button adjusts the
frequency by an interval of 0.1 MHz.
Saving radio stations
Automatically scan for and save radio stations
The appliance has 40 storage slots for radio stations.
 Hold down
until the frequency displayed
automatically continues counting up from
87.5 MHz. The station scan stops automatically as
soon as all available radio stations have been saved
or until all of the save slots have been filled. The
first saved radio station will then begin to play
automatically.
Save slots which are already in use may be
overwritten as a result.
Scanning for and saving stations manually
1. Press one of the save slot buttons 1, 2, 3 or 4, to
save a radio station in that slot.
2. Press < and > to select the radio station you want.
3. Press and hold the previously selected save slot
button 1, 2, 3 or 4 for a few seconds to save the
radio station selected.
Selecting saved radio stations
1. Press MEM.
The save slot of the radio station currently playing is
shown on the display
2. Press < and > to select the save slot you wish to use.
3. Press MEM once again to confirm your selection.
Or:
 Press the save slot button 1, 2, 3 or 4 to bring up
the saved radio station.
Remark: there is a 50cm thin white cable pending at the
backside: this is the antenna. You can move it to
check the best reception of the radio stations.
13