Connecting To The Power Supply; Basic Operation; Fm Radio Operation - LENCO SCD-100BK Mode D'emploi

CONNECTING TO THE POWER SUPPLY

1. Connect the end of the detachable power cord to the unit rear panel AC IN ~ jack and the other end to the AC outlet.
2. Press the STANDBY button to turn on the unit.
Battery powered usage
For DC operation, firstly remove the AC plug from the AC outlet and disconnect the AC cord from the AC IN ~ jack. Then
insert 6 pcs size C (UM-2) batteries into the battery compartment.
Please note: Since the unit draws a little power from the batteries standby mode), remove the batteries if the unit is not
going to be used for a long time.

BASIC OPERATION

Press the STANDBY button to turn on the unit. To turn off, press the STANDBY button again.
FM/CD/USB/SD/BT/AUX
Press the SOURCE button to select different sources.
Volume Control
Press the VOL-/VOL+ buttons to change the volume.
Adjusting the Antenna
The telescopic antenna should be extended and altered to ensure a good FM reception.

FM RADIO OPERATION

Auto Scan
1. Turn on the unit and choose FM mode
2. Press and hold the TUNE- or TUNE+ Button to search for the next available radio station.
Manual Scan
Press the TUNE- or TUNE+ button repeatedly to tune for a different frequency.
Storing FM Presets
You can save up to 20 FM stations.
1. Tune to the station you wish to store.
2. Press the PROGRAM button. Preset channel number will be displayed.
3. Press the TUNE- or TUNE+ button to a preset number that you want to store. Then press the PROGRAM button to save.