Bluetooth Connection - LENCO SCD-100BK Mode D'emploi

BLUETOOTH CONNECTION

Please follow the pairing instructions below to link the unit to your Bluetooth device.
1. Press the SOURCE button repeatedly to enter the Bluetooth mode. The display will show "bt". It will start searching and will keep
flashing.
2. If the unit has never been paired with a Bluetooth device before or cannot find the last paired device, the display and the
Bluetooth status indicator will keep on flashing. Turn on the Bluetooth function of your device and enable the search until "Lenco
SCD-100" is found. Select "Lenco SCD-100" on the Bluetooth device to make connection. Enter the pass code "0000" if required.
3. After successfully paired the unit will display steady "bt" without flashing.
4. You can now start playing music from your smartphone wirelessly to the speaker.
5. You can press the
6. You can press the PREVIOUS

Press the PAIR button on the remote control (or press and hold the PAIR button on the unit) will disconnect the current
connection and start to search another new Bluetooth device
AUX IN
This allows you to connect an external player's sound through your unit.
1. Plug a 3.5mm audio cable (not included) into your external player's line out and the other end into the AUX jack.
2. Press the SOURCE button to enter AUX mode. Display shows "AU"
3. Start your external player to play music.
4. The unit will output the sound.
ENERGY SAVING
Due to ErP stage 2 requirement and protection of the environment, this unit will switch to standby mode automatically when no
music is played for about 15 minutes.
To reactivate the unit, press the STANDBY button again.
CLOCK SETUP
To set the time manually:
1. Turn off the unit to Standby mode.
2. Press and hold the PROGRAM button, the Hour digits will flash.
3. Press the PREVIOUS
4. The Minute digits will flash. Press the PREVIOUS
button to complete the setup.
ACCESSORIES

Power cable x 1

Remote control x 1

Instruction manual x 1
button to pause or resume the playback.
or NEXT button to search to the previous or next song.
or NEXT button to change the hour value. Press the PROGRAM button to continue.
or NEXT button to change the minute value. Press the PROGRAM
12