Language Setup - LENCO SCD-651 Mode D'emploi

OTHER FM MENU OPERATIONS
Press and hold the MENU/INFO button to access the menu control. Then press the PREVIOUS or NEXT
button for different options as described below.
Scan Setting
1. Press and hold the MENU/INFO button to access the menu control.
2. Press the PREVIOUS or NEXT button until "Scan setting" is displayed and then press the SELECT
button.
3. Press the PREVIOUS or NEXT button to toggle between "All stations" and "Strong station". When
"All stations" is selected, all stations will be detected during FM scanning even if the radio station is
noisy. When the "Strong station" is selected, only the strong stations are detected. Scanning will
ignore those noisy stations.
4. Press the SELECT button to confirm.
5. The next time doing a FM scan the unit will search for the stations based on this confirmed setting.
Audio Setting
1. Press and hold the MENU/INFO button to access the menu control.
2. Press the PREVIOUS or NEXT button until "Audio setting" is displayed and then press the SELECT
button.
3. Press the PREVIOUS or NEXT button to toggle between "Stereo allowed" and "Forced mono".
4. Press the SELECT button to confirm.

8. LANGUAGE SETUP

You can set the unit's language.
1. Turn on the unit in DAB mode or FM mode.
2. Press and hold the MENU/INFO button to access the menu control.
3. Press the PREVIOUS or NEXT button until "System" is displayed and then press the SELECT
button.
4. Press the PREVIOUS or NEXT button until "Language" is displayed and then press the SELECT
button.
5. Press the PREVIOUS or NEXT button to toggle between different languages. Select your desired
language and then press the SELECT button to confirm.
6. Press the MENU/INFO button once to re-enter the previous menu level. Or press it repeatedly to exit
the menu control.
9. SOFTWARE VERSION CHECK
You can check the unit software version.
1. Turn on the unit in DAB mode or FM mode.
2. Press and hold the INFO/MENU button to access the menu control.
3. Press the PREVIOUS or NEXT button until "System" is displayed and then press the SELECT
button.
4. Press the PREVIOUS or NEXT button until "SW version" is displayed and then press the SELECT
button to show the software version number.
5. Press the MENU/INFO button once to re-enter to the previous menu level. Or press it repeatedly to
exit the menu control.
12