Fm Radio Operation - LENCO SCD-651 Mode D'emploi

Type of program provided by the broadcaster.
4. Multiplex Name
Displays name of multiplex to which the current station belongs.
5. Channel and Frequency
Current channel number and frequency.
6. Signal Error Rate
It shows the error received. The larger this value the more the error received. To improve the
reception adjust the antenna position.
7. Audio Bit Rate/Audio Type
8. Time
Real time provided by the broadcaster.
9. Date
Current date provided by the broadcaster.
OTHER DAB MENU OPERATIONS
Press and hold the MENU/INFO button to access the menu control. Then press the PREVIOUS or NEXT
button for different options as described below.
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy environment. The DRC
level of a broadcast is set by the broadcaster and transmitted with the service. Changing the DRC value
on your unit enables you to apply a scaling factor to this level.
There are three levels of compression:
DRC high:
DRC low:
DRC off:
1. Press and hold the MENU/INFO button to access the menu control.
2. Press the PREVIOUS or NEXT button until "DRC" is displayed and then press the SELECT button.
3. Press the PREVIOUS or NEXT button to select the DRC value and then press the SELECT button to
confirm.
4. Press the MENU/INFO button to exit the menu control.
Note:
- Not all DAB broadcasts are able to use DRC function. If the broadcast does not support DAB then the
DRC setting in the unit will have no effect.
- After you have adjusted the DRC level the sound may be louder.
Prune
This function removes inactive stations.
1. Press and hold the MENU/INFO button to access the menu control.
2. Press the PREVIOUS or NEXT button until "Prune" is displayed and then press the SELECT button.
3. Press the PREVIOUS or NEXT button to select "Yes" and then press the SELECT button to prune
the unit.
4. Press the MENU/INFO button to exit the menu control.

7. FM RADIO OPERATION

1. Slide the FUNCTION switch to "FM/DAB" for DAB radio mode.
Maximum compression as sent with the transmitted service
Set to 1/2 that of the sent transmitted service
No compression
10