Control Panel - Bartscher JET 110.425 Mode D'emploi

CUTLERY DRYER Models JET - MIG

CONTROL PANEL

0
·
CUTLERY DRIER
Main switch
Main switch
The control panel of the machine is powered at
low voltage (24 volts) to avoid risks originating
from high-voltage power supply.
Main switch: when it is in position 0 it makes it
possible to cut the power supply to the
machine. When it is in position 1 it provides
power to the machine.
Voltage present lamp: indicates that voltage is
supplied to the machine when the main switch
is in position 1.
CDJET-MIG-T-00-07 Use and maintenance manual
.1
Power
supply
lamp
operation lamp
Figure 4 – CUTLERY DRYER control panel, model JET
Power
supply
lamp
Heating
element
operation lamp
Figure 5 – CUTLERY DRYER control panel, model MIG
operation lamp
BREVETTATO
Heating
element
ON • OFF
Run
button
Heating element operation lamp: indicates
operation of the cob heating element. The
power supply
controlled by a thermostat that cuts off the
power supply when the temperature of the
heating element reaches 110°C for the model
JET and 95°C for the model MIG .
Run button: controls start-up of the motor-
vibrator and hence the drying cycle.
Stop button: controls shutdown of the motor-
vibrator and hence the drying cycle.
Machine operation lamp: signals operation of
the motor-vibrator.
Page 6 of 20
Machine
ON • OFF
CAORLE (VE) – V. dell'Artigiano, 10
Tel. 0421 210112 – Fax 0421 218266
Run
button
Machine
operation lamp
Stop button
of the heating
Stop button
element is
CE