Bartscher JET 110.425 Mode D'emploi page 33

CUTLERY DRYER Models JET - MIG
Problem
JET and
JET and
JET and
Excessive noise during
use
JET and
JET and
JET and
JET and
The cutlery has
corncob residue
JET and
After these checks, if the malfunction persists,
contact the dealer's service centre, specifying
the type of defect, the model of the unit (Mod.),
the product number
manufacturing number (S.N.) found on the data
plated with the CE mark.
We suggest you copy these numbers below so
that you will have them handy.
Model : . . . . . . . . . . . . . . . . .
Type : . . . . . . . . . . . . . . . . .
Serial number :. . . . . . . . . . . . . . . . . .
IMPORTANT!:
machine must
qualified personnel. Incorrect repair
may create serious danger to the user.
If your unit requires any repair, contact
your dealer's service centre.
Always insist on original spare parts.
CDJET-MIG-T-00-07 Use and maintenance manual
Model Possible cause
The cutlery is jammed inside the tunnel
MIG
The plate and/or the fastening brackets
MIG are broken or loose
The screws that hold the springs or the
MIG tunnel are loose
Malfunction of the motor-vibrator
MIG
Breakage of tunnel suspension springs
MIG
No corncob in the tunnel
MIG
The cutlery has
MIG correctly or is still damp
The corncob may be damp
MIG
(type) and
Any repairs to
be performed
Remove the lid of the machine, raise the
handle of the tunnel after removing the
three black fastening knobs and remove
the jammed cutlery
Contact the dealer's service centre
Contact the dealer's service centre
Contact the dealer's service centre
Contact the dealer's service centre
Try adding corncob until you reach the
capacity indicated in the paragraph on
technical data in this manual
not been washed Put the cutlery through another washing
and drying cycle
Replace the corncob or leave the machine
running until the corncob is regenerated.
the
the
by
Page 12 of 20
Remedy
Table 1
CE