Disconnecting The Ice Maker; Switching On And Off The Ice And Water Dispenser - V-ZUG POLARIS S Notice De Montage Et D'utilisation

en
Dispensing ice

Disconnecting the ice maker

If ice cubes are not to be dispensed for longer than
1 week (e.g. holiday), temporarily disconnect the ice
cube maker to prevent the ice cubes from freezing
together.
To disconnect the ice maker:
1. Remove the ice cube container.
2. Press the On/Off switch behind the ice cube tray
downwards - ice cube maker is switched off.
3. Empty and clean ice cube container. Re-attach
the ice cube container. Ensure that the ice cube
container engages with the support.
Switching on the ice cube maker again:
Press the On/Off switch behind the ice cube tray
upwards – ice cube maker is switched on.
Note
The description under the On/Off switch is for customer
service only and can be ignored.
42
I
0
Switching on and off the ice
and water dispenser
ã=
Caution
Before switching off the ice maker, it is most
■
important that you switch the water supply
to the appliance off for a few hours.
Empty and clean ice cube container. Re-attach
■
the ice cube container. Ensure that the ice cube
container engages with the support.
Switching the ice and water dispenser off
Simultaneously press "freezer" and "super" buttons
for 5 seconds. "IWD off" is indicated on the display
panel.
Switching on ice and water dispenser
Simultaneously press "freezer" and "super" buttons
for 5 seconds. The "IWD off" display goes out on the
display panel.