Dry Running And Overheating Protection - Graef WK 600 Mode D'emploi

OPERATION
Take hold of the base
●
station and unwind the
cable as far as it goes.
Fill in 1.5 litre maxi-
●
mal.
Important: Do not open the lid during the boiling process.
Make sure you do not exceed the internal maximum filling level mark.
Fill the unit so that the water level is definitely between the minimum and
maximum indicator line.
As soon as boiling stops, the unit automatically shuts off.
●
The indicator light extinguishes.
●
If desired, you can press the on/off switch again to boil the water once
●
more. However, before doing that, please wait about 30 sec. after the unit
automatically shut itself off.

DRY RUNNING AND OVERHEATING PROTECTION

This unit is equipped with a dry running and overheating protection system. If
you ever operate the unit without any water or with too little water, the unit
shuts itself off. Wait a moment until the unit has cooled off. Fill the unit with
water and continue as usual.
16
Plug the plug into the
●
electric socket.
Close the lid.
●
Open the lid and fill
●
the unit with water.
Put the unit back onto
●
the base station and
push the ON-/OFF
switch. The indicator
lights blue and the unit
is switched on.