Hendi BAKE & GRILL-MASTER Mode D'emploi page 7

Cleaning and maintenance
• Let the appliance cool down before cleaning
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• The grid and/or baking tray of the grill should be
cleaned regularly. Let it soak in cleaning agent
first, then use an abrasive material like a scourer
or wire brush. If you use special barbecue clean-
er, follow the instructions on the packaging.
• Clean the ventilation slots (if applicable) with a
vacuum cleaner.
Fault
Fault
Burner will not ignite:
Note
• It is to be recommended to replace the gas hose
after 3 or 4 years (see date shown on hose). The
gas hose becomes porous after a time. Also
check the hose for leaks on a yearly basis at
least. Even if the expiration date has not been
expired yet, you must check the condition of the
hose always. In case of damage/cracks you have
to replace the hose immediately. Please make
sure that you comply with all local health and
safety regulations (e.g. fire code).
Possible cause
Defective igniter
Defective thermocouple
Dirty sparking plug
Defective pressure regu-
lator
Empty gas cylinder
Kink in gas hose
Clogged jet
• Keep inside after use.
• Let specialised personnel clean at least once a
year the burner.
• Never use a high pressure cleaner.
• Maintenance after every use: Clean the griddle.
Clean the grease holder.
• If the injector must be replaced, replace it only
with an original spare part acquired from the
manufacturer. The diameter of the injector is
noted on the injector: 1.10 mm.
Fault
Burner does not burn fully:
• Pressure regulators have a default maximum life
span as indicated by the date printed on the regu-
lator, but please note that local health and safety
regulations may overrule this.
• Only replace the pressure regulator with one pro-
vided by the manufacturer.
• Consult the local regulations, these may differ.
• Always store gas bottles upright, in use as well
as when empty.
Possible cause
Gas cylinder is (almost)
empty
Kink in gas hose
The main gas tap on the
gas cylinder is not fully
open
Defective gas tap
Main jet clogged
7
EN